• Always check the User Manual for guidance on the safe use of your NutriBullet 900 Series. Also refer to the Safety information topics in this guide for information.

    WARNING: The extractor blade is very sharp. Handle with care.

    Never leave the NutriBullet 900 Series running for more than one minute at a time, or for more than 3 consecutive one minute intervals.

    Never blend heated or carbonated ingredients, this could cause the cup to pressurize and leak.
  • 1.

    The Shake technique is ideal if any of the ingredients are not making it to the blade and get caught at the top of the cup.


    Place your prepared ingredients into the desired cup.

  • 2. Add the desired liquid up to the MAX level.
    Always ensure that your mixture contains enough liquid for the ingredients to move.
  • 3.

    Place the extractor blade onto the cup.

  • 4.

    Turn the extractor blade clockwise to form a tight seal.

  • 5.

    Plug the power lead into the mains power.

  • 6. Line up the tabs on the cup with the tabs on the power base.
  • 7. Press the cup down onto the power base and twist the cup clockwise. This will lock the cup into the power base.
    The unit will activate as soon as the cup is pressed down.
  • 8. Let the power base run for up to 1 minute.
    CAUTION: Allow the extractor blade to stop spinning completely before removal.
  • 9.

    Turn the cup anticlockwise to release the tabs, while holding the power base with your other hand.

  • 10.

    Wait for the power base to stop completely then remove the cup from the power base.

    Removing earlier than this will lead to increased wear on both the extractor blade and power base.
  • 11.

    Shake the cup (like a cocktail shaker).

  • 12.

    Repeat the technique until you get the desired consistency.

    Never run the extractor blade for more than three consecutive one minute intervals.
  • 13.

    Turn the cup anticlockwise to release the tabs, while holding the power base with your other hand.

  • 14.

    Wait for the power base to stop completely then remove the cup from the power base.

    Removing earlier than this will lead to increased wear on both the extractor blade and power base.
  • 15.

    Remove the power lead from the mains power.

  • 16. Turn the extractor blade anticlockwise.
  • 17.

    Remove the extractor blade and then serve.