• Always check the User manual for guidance on the safe use of your Verti Steam Pro.


    DO NOT use horizontally, the Verti Steam Pro has been designed for vertical use only.
    DO NOT aim the Verti Steam Pro at people or animals or steam clothes being worn.


    Remember: You will be working with hot water and steam, so always ensure that all the safety requirements are fully in place before using and please exercise care and caution as you follow the steps in the guide.

  • 1.

    Before steaming any garments, make sure the water tank is full.

    Do not exceed the MAX line. For more information, see the Filling the water tank topic.
  • 2.

    Plug the Verti Steam Pro into the mains power.

  • 3.

    Press and hold the on/off button until the blue light begins to flash, then release the on/off button.

    The blue light will then remain on whilst the Verti Steam Pro is ready to use.
  • 4.

    The blue light will flash for approximately 45 seconds until the Verti Steam Pro reaches temperature.

    The blue light will then remain on whilst the Verti Steam Pro is ready to use.

  • 5.

    Squeeze the steam trigger on the front of the Verti Steam Pro.

    The steam can take a few seconds to be start, during this time the pump will sound louder than usual.

  • 6.

    Hold the Verti Steam Pro 2cm away from the garment you want to steam.

    Create tension in the fabric by lightly pulling the bottom edge of the garment, this can improve results and speed up the process.

  • 7.

    When steaming your garments, the trigger can be locked into the ON position by squeezing the steam trigger and sliding the inner trigger down.

  • 8.

    To unlock the trigger slide the inner trigger up.

  • 9.

    When you have finished steaming the garment release the steam trigger.

    Refer to the user manual for suggested tips on steaming your garment.

  • 10.

    Press and hold the on/off button until the blue light goes out.

  • 11.

    Unplug the Verti Steam Pro from the mains power.

  • 12.

    Press the water tank release button (white button) to release the water tank.

  • 13.

    Pull the water tank away from the Verti Steam Pro.

  • 14.

    Pull out the rubber stopper.

    Never remove the rubber plug from the side of the water tank.
  • 15. Pour away any water that is left in the water tank and replace the rubber stopper.
    Never remove the rubber plug from the side of the water tank.
  • 16. Slide the water tank back into place.
    The Verti Steam Pro will make a soft click as it locks into place.